AT&T feature module 2 system manual PBX, Centrex, or Custom Calling Features

HOW TO USE To dial an outside number with one touch:

1 Without lifting your handset, touch the Outside Auto Dial button for the number you want to dial.

Your voice terminal speaker goes on and you hear dialing.

2 When you hear the other person answer, lift your handset or speak into your speakerphone.

If the line is busy or if no one answers.

1 Touch Speaker to cancel the call.

You can also lift your handset and then touch an Outside Auto Dial.

PBX, Centrex, or Custom Calling Features

DESCRIPTION	Your MERLIN II system may work behind a PBX or a Centrex system and be
	configured for behind-switch operation. You may also use non-MERLIN
	Custom Calling features. If you are operating behind a host system or using
	non-MERLIN Custom Calling features, keep these points in mind:
	When PBX, Centrex, or Custom Calling instructions tell you to include a
	switchhook flash, touch Recall instead. If you touch the switchhook, you
	disconnect your call.
	If your system is administered for behind-switch operation, you use PBX,
	Centrex, or Custom Calling feature codes that begin with a pound sign
	( # ) as described in their documentation. To use MERLIN II system
	feature codes that begin with # while you are off hook (you hear a dial
	tone or you are on a call), you must program a Speed Dial Access button,
	as shown below. You touch Speed Dial Access instead of touching #,
	then dial the rest of the code.
	If your system is not administered for behind-switch operation, you use
	MERLIN II system feature codes that begin with # as described in this
	manual. To use PBX, Centrex, or Custom Calling codes, you dial two
	pound signs instead of one. For example, if the PBX code is # 1234, you
	dial # # 1234.
PROGRAMMING	For programming procedures for Recall, see “Recall. ”
	To program a Speed Dial Access button, label a button, enter programming
	mode, and follow these steps:
	1 Touch the button you want to program.
	2 Dial ’20.
	3 Program another feature, or leave programming mode.

2-128MERLIN II System Features