AT&T feature module 2 system manual Dial pool code, To assign lines and line pools to voice

Administration Procedure	Do This
Voice terminal hne/line pool assignments
in pooled systems:
To assign lines to line pools	1 Touch Adm Pool.
	2 If green light next to Adm Pool is steady and you hear two beeps,
	go on to step 3. If not, wait for 2-beep signal or try again later.
	3 Dial pool code.
	4 Touch line buttons:
	Steady red on = line in pool
	Red off = line not in pool
	5 Touch Adm Pool.
To assign lines and line pools to voice	1 Touch Adm Tel.
terminals	2 Touch Auto Intercom buttons for voice terminal.
	3 If steady green light shows next to Adm Tel and you hear two
	beeps, go on to step 4. If not, wait for 2-beep signal or try again
	later.
	4 Touch line buttons:
	Steady green on = line or pool assigned to voice terminal
	Green off = line or pool not assigned to voice terminal
	5 Touch Adm Tel.
To assign Dial Access to Line Pools to	1 Touch Adm Tel.
voice terminals	2 Touch Auto Intercom button for voice terminal.
	3 If steady green light shows next to Adm Tel and you hear two
	beeps, go on to step 4. If not, wait for 2-beep signal or try again
	later.
	4 Touch same Auto Intercom button again.
	5 Touch line buttons:
	Steady green on = voice terminal has Dial Access to pool containing
	line
	Green off = voice terminal doesn‘t have Dial Access to pool
	containing line
	6 Touch Adm Tel.

Button Code Administration Procedures 3-5