AT&T feature module 2 system manual S t

3 Go on to another procedure, or leave administration mode.

With a BIS-34D Console

1 Touch Message.

2 Dial	#202 and wait for the 2-beep signal to begin.
3 Dial	one of the following digits to specify the system type:

●0 = square system.

●1 = pooled system with Button Access to Line Pools.

●2 = pooled system with Dial Access to Line Pools.

●3 = pooled system with Automatic Route Selection.

●4 = behind-switch system.

4 After several seconds, the lights next to Adm Pool, Adm Tel, Message, and Speaker begin to flash. At this signal, go on to another procedure, or leave administration mode.

T e s t

DESCRIPTION	When you need to test the lights and the ringing on your voice terminal, or if
	you need to verify that your voice terminal has been installed correctly, you
	can use the following operations.
	● For analog voice terminals, use the Test/Program (T/P) switch on the left
	side of your analog voice terminal.
	● For digital voice terminals, place a test call on your voice terminal.
HOW TO USE	If you have an analog voice terminal, follow these steps:
	1 Slide the T/P switch to T.
	The red and green lights next to your voice terminal buttons flash alternately, and your
	voice terminal rings.
	2 Slide the T/P switch to the center position.
	If your voice terminal does not respond when you slide the T/P switch to T,
	notify your system administrator and check Section 5, “Troubleshooting,” in
	the MERLIN II System Installation and Administration Manual.
	If you have a digital voice terminal, follow these steps:
	1 Lift your handset.
	2 Listen for a dial tone. (If this is a newly installed system, it may take a
	few moments to recognize your voice terminal and supply a dial tone.)
	3 Place a test call to another voice terminal.
	4 Place a test call to your voice terminal from another voice terminal.
	If any of these tests are unsuccessful, notify your administrator.

MERLIN II System Features 2-157