AT&T feature module 2 system manual Touch Conference, Drop, or Transfer, Speed Dial Access Button

With a BIS-34D Console

1Touch Message.

2Dial # 202.

If the system can be administered, the green light next to Message is steady.

3When you hear a 2-beep signal to begin, dial 4.

After several seconds, the lights next to Adm Pool, Adm Tel, Message, and Speaker begin to /lash.

4Touch Message,

5You can assign dial codes of up to six digits to the Conference, Drop, and Transfer buttons to access these features in the host system. To assign codes:

a Dial #328.

b Touch Conference, Drop, or Transfer.

c To assign a host system access code to the button, dial the appropriate code (up to 6 characters, including O through 9, *, #, Hold [pause], and Recall). If you don’t dial a code, the button keeps the default feature, Recall.

6Touch Message and go on to another procedure, or leave administration mode.

PROGRAMMING	In systems set for behind-switch operation, you can program buttons that let
	you:
	● Use dial codes to access features while you’re on a call
	● Use the MERLIN II system Conference, Transfer, and Drop features
	instead of the equivalent features of the host system
	Speed Dial Access Button
	To program a Speed Dial Access button, label an available button, enter
	programming mode, and follow these steps:
	1 Touch the button you want to program.
	2 Dial	*20.
	3 Leave	programming mode.

Local Conference, Drop, and Transfer Buttons

To program fixed feature buttons for use with the MERLIN II system only, label the button(s), enter programming mode, and follow these steps:

1 Touch the button you want to program.

2 Dial the appropriate code:

Dial *96 for Local Conference

Dial *97 for Local Drop

Dial *99 for Local Transfer

3 Program another feature, or leave programming mode.

2-22MERLIN II System Features