AT&T feature module 2 system manual Touch Recall, On buttons at the voice terminals

NOTE: If the voice terminal is being used, the green light next to Adm Tel flashes rapidly. You must wait until the green light become steady

and you hear the 2-beep signal or leave administration mode and try again later.

Steady green lights show next to the buttons of the lines assigned to buttons on this voice terminal. Steady red lights show next to the buttons of each line assigned to one of the system pools.

3 Touch the same Auto Intercom button.

A steady red light comes on next to the green light beside Adm Tel.

If you are trying to assign Dial Access to a line pool to an attendant’s console or to a busy voice terminal, the red light will not come on and the system will beep.

4 Touch the button next to one of the lines in each of the pools whose

status you want to change. The green light beside the button for the line tells you whether the voice terminal has Dial Access to the pool that contains this line. Each successive touch of a line button gives you one of the following codes:

Green light on = voice terminal has Dial Access to this pool

Green light off = voice terminal does not have Dial Access to this pool

Keep in mind that the lines in a pool always change as a group. Touching any button representing a line in a pool affects all the lines in that pool.

5 Repeat steps 2 through 4 for each voice terminal whose Dial Access to

Line Pools you want to change.

6 If you want to give a different voice terminal the same Dial Access to Line

Pools as a voice terminal that has already been set up, use the following shortcut. Note that when you copy the Dial Access assignments, you also copy all call restrictions, allowed-list permissions, and line and pool assignments from the original voice terminal.

a Touch the Auto Intercom button of the new voice terminal.

b Touch Recall

	The red light next to Adm Tel goes on.
	c Touch the Auto Intercom button of the original voice terminal.
	When the red light goes off, the copy procedure is complete.
	7 Touch Adm Tel and go on to another procedure, or leave administration
	mode,
HOW TO USE	Be sure that the line pools and any individual lines that you assign are labeled
	on buttons at the voice terminals.
	The guides for users and attendants explain how to place calls in different
	types of pooled systems. Be sure that everyone in your business knows what
	type of system yours is and understands how to use the line pools.

2-98MERLIN II System Features