AT&T feature module 2 system manual With a BIS-34D Console, Touch Adm Pool

With a BIS-34D Console

To set up line pools and assign line pools and lines to stations, enter administration mode and follow the appropriate procedure below.

Assigning Lines to Line Pools

1Touch Adm Pool.

NOTE: If the green light next to Adm Pool flashes instead of remaining steady and you don’t hear a 2-beep signal, your lines are in use. You cannot set up line pools unless all the voice terminals in your system are idle. Wait until you hear the 2-beep signal or leave administration mode and try again later.

2When you entered administration mode and touched Adm Pool, the system put you in the main pool (default pool 9). If you want to administer any other line pool, you must dial the pool’s access code (default codes are 890 through 899).

3Steady red lights appear beside each line that is assigned to this pool. Touch the button of any line whose pool assignment you want to change. Each touch of the button gives you one of the following codes:

Red light on = line is assigned to the pool

Red light off = line is not assigned to the pool

If you hear a beep when you touch a line button, the line is already in another pool or assigned to Music-on-Hold or Loudspeaker Page. You must remove the line from its current pool by dialing that pool’s access code and touching the line button before you can assign the line to the pool you are administering.

4To administer another pool, dial the appropriate access code and repeat step 3.

5To make sure that your line pools are set up as you want them, dial the access code of each line pool in turn and verify that the steady red lights are on next to the correct line buttons.

6Touch Adm Pool and go on to another procedure or leave administration mode.

Assigning Line Pools or Lines to Buttons Follow the procedure below to assign or remove lines or line pools from voice terminals. If you’re assigning lines, be sure to touch the buttons in the order in which they appear on the Station Configuration Form.

It’s advisable to keep line buttons together on a voice terminal. If you remove a line in the middle of a column of line buttons, it’s best to reassign the remaining lines so that the lines appear on an unbroken sequence of buttons.

1 Touch Adm Tel.

2 Touch the Auto Intercom button for the voice terminal to which you want to assign line pools or lines.

A steady green light comes on next to its Auto Intercom button. The system gives you a

2-beep signal to begin.

2-96MERLIN II System Features