AT&T feature module 2 Basic Administration Procedures, Administration Procedure Do This

Button Code Administration Procedures

Button code administration procedures are divided into two categories: basic

and optional procedures.

Basic Administration Procedures

Administration	Procedure			Do This
System size		1 Touch Message.
		2 Dial	#201.
		3 If green light next to Message is steady and you hear two beeps, go
		on to step 4. If not, wait for 2-beep signal or try again later.
		4 Dial number to designate system size:
		o = small system
		1 = large system
		5 Wait for lights next to Adm Tel, Adm Pool, Message, and Speaker
		to flash. At this signal, go to another procedure or leave
		administration		mode.
System type		1 Touch Message.
		2 Dial	#202.
		3 If green light next to Message is steady and you hear two beeps, go
		on to step 4. If not, wait for Z-beep signal or try again later.
		4 Dial number to designate system type:
		0 = square
		1 = pooled with Button Access to Line Pools
		2 =	pooled with Dial Access to Line Pools
		3 = pooled with Automatic Route Selection (ARS)
		4 = behind-switch
		5 Wait for lights next to Adm Tel, Adm Pool, Message, and Speaker
		to flash. At this signal, go to another procedure or leave
		administration		mode.
System Renumbering	Procedure	1 Touch Message.
		2 Dial	#299.
		If the light next to Message flashes by itself, one or more calls are in
		progress and the procedure is not executed–wait for the light to
		become steady, then go on to the next step.
		3 When the lights next to Adm Tel, Adm Pool, Message, and Speaker
		begin to flash, go to another procedure or leave administration
		mode,

3-2Button Code Administration Procedures