AT&T feature module 2 system manual At an Analog Voice Terminal, At a Digital Voice Terminal

ENTERING AND LEAVING PROGRAMMING MODE

INTERPRETING FORCED IDLE SIGNALS

GETTING PRINTOUTS

To program a feature at a voice terminal, you label an available button with the name of the feature, such as “Last Number Redial, ” or a person’s name, then put the voice terminal into programming mode, as shown below. How you enter and leave programming mode depends on whether the voice terminal is an analog model such as the 5-button, 10-button, 22-button, or

34-button voice terminal or a digital model such as the 7406 and 7406D voice terminal. If the voice terminal has a display, it shows you the features and options you have selected.

NOTE: Voice terminals in programming mode ring every five seconds to remind you that you’re programming and that you can’t place or receive calls. Remember not to lift the handset while you are programming.

At an Analog Voice Terminal

To put an analog voice terminal into programming mode:

1Slide the T/P switch to P.

To return to regular call-handling mode:

1Slide the T/P switch to the center position.

At a Digital Voice Terminal

To put a digital voice terminal into programming mode:

1Dial # 33.

To return to regular call-handling mode:

1Dial #00

In order for you to perform certain basic administration procedures, the system must be idle, that is, have no calls in progress. If you get the message “System Busy, ” you must wait until the system is idle or try the procedure again later.

If you have a printer, you can get printouts that show how certain features have been administered. You order printouts by entering a code or touching a button at the administrator/attendant console while you’re in administration mode. Instructions for getting printouts are included in the administration procedures.

NOTE: Be sure to wait until the printout is completed before leaving administration mode. Don’t remove the printout until you’ve left administration mode, or your page alignments will be affected.

2-4MERLIN II System Features