AT&T feature module 2 system manual Enter and Leave, Administration Mode

Introduction

This guide summarizes the administrative procedures described in Section 2,

	“Reference.” For more information about a particular procedure, refer to the
	entry for that feature. Separate procedures are provided for the BIS-34D
	console and the MERLIN II System Display Console.
	Before you perform any of these procedures, be sure to record the change or
	addition you’re making on your planning forms. These may include your
	Master Planning Form, System Configuration Form, Station Configuration
	Forms, and forms for optional system features such as Group Page.
	If you have a BIS-34D console, some of the buttons take on different functions
	when you’re in administration mode. For example, you touch Recall to copy
	assignments from one voice terminal to another and Message to designate
	attendant consoles. If you have a MERLIN II System Display Console, place
	the administration overlay over the console whenever you administer the
	system. The overlay shows the buttons’ functions.
ENTER AND LEAVE	To perform any of the procedures listed in this guide, enter administration
ADMINISTRATION MODE	mode by following these steps:
	1 Slide the T/P switch on the left side of the console to P.
	2 Touch Conference twice to enter administration mode.
	When you finish administering your system, leave administration mode by
	sliding the T/P switch to the center position.

Introduction 3-1