AT&T feature module 2 system manual From Administration Menu Touch These

ADMINISTRATION	Before you begin, be sure your system is set for square configuration. See
	“System Type. ” Have the Station Configuration Forms handy. To assign
	lines to buttons in a square system, enter administration mode and follow the
	appropriate procedure below.
	With a MERLIN II System Display Console
	1 From	the	administration	menu,	touch	these	buttons: [Stations], [Line/Pool] .
	2 Touch	the	Auto Intercom	button	for the	voice	terminal.

3Touch [Enter].

NOTE: If the voice terminal is being used, the message, “station busy - please wait, ” shows on your display. You must either wait until the station becomes available or try again later.

4 Touch the line buttons until the correct code shows:

Green light on = line is assigned to the voice terminal

Green light off = line is not assigned to the voice terminal

If you want to give another voice terminal the same line assignments as one you have already set up, use the following shortcut:

NOTE: Be aware that when you copy line assignments, you also copy call restrictions and allowed-list permissions. Be sure you want the two voice terminals to be identical in these respects before using this Copy procedure.

a Touch [Copy] .

b In response to the prompt, touch the Auto Intercom button of the station you are copying from.

CTouch [Enter] .

d In response to the prompt, touch the Auto Intercom button of the station you are copying to.

eTouch [Enter] .

You hear a 2-beep signal to let you know that the copy procedure is complete.

f Repeat steps b through e for each voice terminal for which you want to copy line assignments.

g Touch [Exit] to return to the Stations screen.

5 To make line assignments to a different voice terminal, repeat steps 2 through 4.

6 Touch Conference to return to the administration menu, or leave

administration mode.

With a BIS-34D Console

1 Touch Adm Tel.

2 Touch the Auto Intercom button for the voice terminal to which you want to assign lines.

A steady green light comes on next to the voice terminal’s Auto Intercom button. The

system gives a 2-beep signal for you to begin.

2-102MERLIN II System Features