AT&T feature module 2 system manual Touch Conference, Enter the #

To assign a consequential System Speed Dial code, touch [Enter] and repeat steps 2 through 4.

6 Touch Conference to return to the administration menu, or leave

administration mode.

With a BIS-34D Console

1Touch Conference.

The red light next to Adm Tel goes on.

2Dial 0.

3Dial a System Speed Dial code ( #60 to # 99).

4If you are storing a marked Speed Dial code, dial * after dialing the System Speed Dial code.

5Dial the telephone number, including a leading 1 where required. If your system is pooled with Dial Access, include the pool number on which the call should be placed in the Speed Dial code.

NOTE: A number for a marked Speed Dial code can have up to 39 characters; a number for an unmarked Speed Dial code can have up to 40 characters. These characters can include a pause, a stop, a switchhook flash, or Touch-Tone enable, mentioned above. It is best to include a pause between the pool number and the telephone number (touch Hold) when you administer a Speed Dial code that includes a pool number.

The display shows the telephone number, including any special characters, as you dial it. If the number is not correct, perform the step again.

6Repeat steps 3 through 5 for each telephone number or account number to which you are assigning a System Speed Dial code.

7Touch Conference twice.

8If you have a printer connected to your system, you can get a printout of your System Speed Dial code numbers by touching Message and dialing # 901.

All 40 codes (#60 through # 99) are printed out, even if some are not yet assigned to telephone numbers, If a number includes special characters, they will appear as t for Touch-Tone enable, s for stop, p for pause, or r for recall.

9Touch Message and go on to another procedure, or leave administration mode.

PROGRAMMING	To program a System Speed Dial code, label a button, enter programming
	mode, and follow these steps:
	1 Touch the button you want to program.
	2 Dial *95 plus a 2-digit System Speed Dial code (60 through 99—do not
	enter the “ # “)
	3 Program another feature, or leave programming mode.

MERLIN II System Features 2-155