AT&T feature module 2 system manual From the administration menu, touch More, More, CntrPrg

With a MERLIN II System Display Console

1 From the administration menu, touch [More], [More], [CntrPrg] .

2 Touch the Auto Intercom button for the voice terminal to be programmed. 3 Touch [Enter] .

4 If the red light next to Adm Tel goes off and the console rings every 5 seconds, go on to step 4. If not, wait for the light to go off or try again later.

5 Perform the steps shown in the programming procedure for the feature, except for entering and leaving programming mode.

6 Touch Conference to return to the administration menu, or leave administration mode.

With a BIS-34D Console

1When you see lights flash next to Adm Pool, Adm Tel, Message, and Speaker, indicating that you are in administration mode, touch

Conference.

The red light next to Adm Tel goes on.

2Dial the intercom number for the voice terminal you want to program. The red light next to Adm Tel goes on.

NOTE: If the voice terminal you want to program is busy, the red light next to Adm Tel and the green light next to the Auto Intercom button flash alternately. You must wait for the voice terminal to become idle before going on. If you prefer not to wait, you can touch Conference again and select another voice terminal to program, or touch Conference twice to stop programming.

3When you hear two beeps, you can begin Centralized Programming. Follow the programming procedures described under the individual features.

4To program another voice terminal, repeat steps 1 through 3.

5Touch Conference twice to go on to another administration procedure or leave administration mode.

2-38MERLIN II System Features