AT&T feature module 2 system manual Reach screen via Lines, Disa, Inward only

Administration Procedure			Do This
Camp On:
To set the Camp On return interval		1 Reach screen via [More], [Options] [CampOn] .
		2 Enter the number of minutes (1 through 5) that calls should remain
			camped.
		3 Touch [Enter] .
		4 Touch Conference to return to the administration menu.
	1		Reach screen via [More], [More], [Cntr-Prg].
Centralized Programming
		2 Touch Auto Intercom button for voice terminal to be programmed.
		3 Touch [Enter] .
		4 If red light next to Adm Tel goes off and console rings every
			5 seconds, go on to step 5. If not, wait for light to go off or try
			again later.
		5 perform programming steps, except for entering and leaving
			programming mode.
	6		Touch Conference to return to the administration menu.
Dialing Timeout for rotary lines		1 Reach screen via [More], [Options], [More], [More], [Rotary] .
	2		Dial number to specify timeout interval:
			0 = 0 seconds
			1 = 4 seconds
			2 = 8 seconds
			3 = 12 seconds
	3		Touch Conference to return to the administration menu.
Direct Inward System Access		1 Reach screen via [Lines], [DISA] .
	2		Dial a four digit password, or touch Drop to remove entry.
	3		Touch [Enter] .
	4		Touch [NoRestr] for no restriction, or touch [InwdOnly] for
			inward only.
		5 Touch line button:
			Green light on = line or line pool can be used for DISA
			Green light off = line or line pool cannot be used for DISA
		6 Touch Conference to return to the administration menu.

. . .

3-32Menu-Driven Administration Procedures