AT&T feature module 2 Dial this, Label the button Programming code, Display Voice Terminals

A person who is sending a message from a display voice terminal sees on the display, “Message Box Full. ”

●If the administrator shuts down the system for a moment (force idles the system), you will need to touch Message again to read your messages. If there is a power failure, all messages in your message files are deleted.

PROGRAMMING	To program the Deliver Message, Return Call, Delete Message, Next Message,
	and Scroll features as well as a-Message button, if you do not already have
	one on your voice terminal, then label the button (see the table under step 4
	for button labels and programming codes) and use these procedures:
	1 Enter programming mode.
	2 Touch the button you want to program.
	3 For each feature, use the programming code listed here.
				Dial this
		Label the button:		programming code:
		Delete Message		*78
		Deliver Message		*83
		Message	I	*98
		Next Message		*80
		Return Call		*79

Scroll

*81

	4 Leave programming mode.
HOW TO USE	The procedures for using the Leave Word Calling features are the same for
	any voice terminal.
	Procedures for the BIS-34D with Display, 34-Button BIS with Display Unit,
	and 7406 Display Voice Terminals
	If you have programmed a Deliver Message button on your voice terminal,
	you can leave word that you have called at a display voice terminal that is
	busy or unattended.
	1 Before you hang up, touch the Deliver Message button that you have
	programmed.
	If you have a display voice terminal, you can check your display screen for
	information that came in for you while you were away from your desk:
	(People with 7406 display voice terminals must program a Message button, or,
	if they prefer, they can use a dial code. See “Message.”)
	1 If your Message light is on, touch Message.

2-82MERLIN II System Features