AT&T feature module 2 Auto Answer-All, Go on to another procedure, or leave administration mode

4 Go on to another procedure, or leave administration mode.

With a BIS-34D Console

1 Touch Message.

2 Dial # 203.

NOTE: If you see the message “Wait: System Busy, ” wait for the prompt or try this procedure again later.

3 Check the lights next to the Auto Intercom buttons. A green light goes on next to the button for each station already designated as an attendant position. A flashing green light goes on next to the button for each station that can be used as an attendant position. No lights go on next to the buttons for stations that cannot be attendant positions.

4 Touch the Auto Intercom buttons until the green light next to the button shows the setting you want:

Green light on = this station is an attendant position.

Green light flashing = this station can be but is not now an attendant position.

5 Dial #.

6 After several seconds, the lights next to Adm Pool, Adm Tel, Message, and Speaker begin to flash. At this signal, go on to another procedure or leave administration mode.

Auto Answer-All

DESCRIPTION

CONSIDERATIONS

If you want calls to be answered automatically by an optional modem or an answering machine connected to your voice terminal, you need to program an Auto Answer-All button.

●YOU can have both Auto Answer-All and Auto Answer-Intercom programmed for your voice terminal; however, the two buttons cannot be turned on at your voice terminal at the same time.

●If you want an answering machine to answer intercom calls, use the Auto Answer-All rather than the Auto Answer-Intercom feature. If you try to use an answering machine with the Auto Answer-Intercom feature, it may cause intercom calls to be dropped.

●If you want an answering machine to answer only intercom calls, not outside calls, program all your lines for no ring. (See “Ringing Options.”)

●In order to use a modem or answering machine with your analog voice terminal, you must have a General Purpose Adapter. (See “General Purpose Adapter” under “Accessory Equipment. ” )

●If you have an Hands Free Unit, see “Auto Answer-Intercom,” below.

2-10MERLIN II System Features