AT&T feature module 2 Attendant console position, Touch Auto Intercom buttons, Touch #, Dial #204

Administration Procedure	Do This
Attendant console position	1 Touch Message.
	2 Dial # 203,
	3 If green light next to Message is steady and you hear two beeps, go
	on to step 4. If not, wait for 2-beep signal or try again later.
	4 Touch Auto Intercom button(s):
	Steady green = attendant position
	Flashing green = potential attendant position used as nonattendant
	position
	5 Touch # .
	6 Wait for lights next to Adm Tel, Adm Pool, Message, and Speaker
	to flash. At this signal, go to another procedure or leave
	administration mode.
Music-on-Hold jack	1 Touch Message.
	2 Dial #204.
	3 If green light next to Message is steady and you hear two beeps, go
	on to step 4. If not, wait for 2-beep signal or try again later.
	4 Touch line button:
	Green light on = Music-on-.Hold jack
	Green light off = standard line or Loudspeaker Page jack
	5 Touch Message.
Loudspeaker Page jack	1 Touch Message.
	2 Dial #205.
	3 If green light next to Message is steady and you hear two beeps, go
	on to step 4. If not, wait for 2-beep signal or try again later.
	4 Touch line button:
	Green light on = Loudspeaker Page jack
	Green light off = standard line or Music-on-Hold jack
	5 Touch Message.
Simultaneous Voice and Data	1 Touch Message.
	2 Dial #211.
	3 If green light next to Message is steady and you hear two beeps, go
	on to step 4. If not, wait for 2-beep signal or try again later.
	4 Touch either of two adjacent Auto Intercom buttons:
	Green light on = station jack part of voice/data pair
	Green light off = station jack not paired
	5 Touch Message.

Button Code Administration Procedures 3-3