GE 68K System manual CCB Create Configuration Storage Block

	68K System Monitor
GE Energy Services	User's Guide

CCB - Create Configuration Storage Block

Platform

Description

o CPM o D20	o D20 ME	þ D20/200	þ D20/200 ME	þ D25
D20 Base	D20 Base	CCU Base	CCU Base

Use this command to create the configuration storage block at a specified location or allocate it out of RAM.

The amount of memory space allocated to configuration storage and other relevant parameters are also required.

•The Monitor invalidates any existing storage block before creating the new one.

−If requested to make the block in NVRAM, the command assumes it to be a part of a static configuration storage region and will simply use the memory as specified (base address and size).

−By specifying RAM, the monitor expects the block to be temporary, and allocates memory out of normal pSOS RAM.

Syntax

!

WARNING

Below is usage and syntax information for this command

Any existing stored configurations will be lost when this command is invoked!!!

Command Format	ccb [/(n v r)] base_address total_ram response_file_size
	num_cfgs nvram_base
Variables	/n	=	Build configuration block in global NVRAM
			region using the base_address supplied.
	/v	=	Allocate the configuration block from normal
			RAM, ignoring the base address.
	/r	=	Reset CCB. Old CCB is cleared before new one
			created
Parameters	base_address = Address of start of configuration storage
			region, in hexadecimal (must be present, even
			if it’s just zero for RAM configuration
			blocks).
	total_ram		= Total amount of NVRAM allocated to the
			region, in bytes.
	response_file_size
			= Size of response file, in bytes.
	num_cfgs		= Total number of configurations to store,
			maximum of 2.
	nvram_base		= Address of start of NVRAM region.

Continued on next page

SWM0023 1.00 2 General

3-12 Full Release