GE 68K System manual JX Jam Exchange, Type jx 304540 1 2 3 4 and press Enter

68K System Monitor

User's Guide GE Energy Services

JX - Jam Exchange

Platform

Description

Syntax

þ CPM þ D20	þ D20 ME	þ D20/200	þ D20/200 ME	þ D25
D20 Base	D20 Base	CCU Base	CCU Base

Use this command to force a message to the beginning of the message queue at one or more exchanges.

Below is usage and syntax information for this command

Command Format	CPM / D20 / D25: jx (xid name) m2 m3 m4 m5
	CCU / CCUME:		jx (xid gxid name) m2 m3 m4 m5 [/g]
Variables	/g	= Allows the message to be jammed into a queue in
		a different node
Parameters	xid	= pSOS exchange ID (in hexadecimal); send
		message to a specific exchange.
	gxid	= global exchange ID (in hexadecimal); send
		message to a specific exchange.
	name	= case-sensitive exchange name. The command
		supports the new exchange naming convention. If
		you enter an entire name, the monitor sends the
		message to that exchange. If you enter the first
		few characters, the command attempts pattern
		matching. It sends the message to one or more
		exchanges depending on the number of matches.
	m2 - m5	= first through fourth long words in the body of the
		message, in hexadecimal.
Example	Type jx 304540 1 2 3 4 and press ENTER.
	This sends a message to an exchange identified as 304540. The
	command sets the first two reserved messages to 0.
	Results: Unless it encounters an error, the system displays the
		prompt. In the case of an error, it displays an error
		message before the prompt.
Special	You must only use this command in a testing or debugging
Considerations	context. If you send an indiscriminate message to an exchange,
	you cannot predict the results.

General SWM0023-1.00 -2

Full Release 3-43