| 68K System Monitor |
GE Energy Services | User's Guide |
|
|
HT - HDLC Test
Platform
Description
Syntax
o CPM þ D20 | þ D20 ME | o D20/200 | þ D20/200 ME | o D25 |
D20 Base | D20 Base | CCU Base | CCU Base |
|
Use this command to transmit specific application messages over the HDLC communication link.
Note: | Because you must assemble these messages by hand, you can not use the |
| command effectively unless you know the protocol used by the D.20 |
| application. |
Below is usage and syntax information for this command
| Command Format | ht /(c m r s w) |
| |
|
|
|
|
|
| Variables | /c | = configure the link parameters |
|
|
| /m | = define the application message |
|
|
| /r | = read (monitor) the link |
|
|
| /s | = display configuration status |
|
|
| /w | = send an application message |
|
|
|
|
|
|
| Parameters | None |
|
|
|
|
|
| |
| Example | None required |
| |
|
|
|
| |
| Special | This command is not available on the CPM. |
| |
| Considerations | This command is not available if the D.20 (B003) application |
| |
|
|
| ||
|
| is active. |
|
|
|
|
|
|
|
|
|
|
|
|
SWM0023 1.00 2 | General |
Full Release | |
|