EXP Computer PCMCIA Ethernet Modem Adapter Installation Testing the Modem, Testing the Network

Page 11

INSTALLATION

TESTING THE MODEM

This section contains steps to verify the installation of the ThinCom Modem portion by using a communication software.

1.Install and start a data communication software. (for Microsoft Windows users Click on Accessories Group => Terminal) Select terminal mode.

2.In setup modem, set COM port to match COM Port previously set by the PC Card device driver

3.Set Baud Rate, Data bits, Parity, Flow Control and Stop bit parameters to your normally use.

4.Enter the terminal mode. This will allow you to issue the 'AT' command directly to the modem.

5.Type 'AT' or 'at' then press ENTER (Note:key. the modem will not recognize mixed case such as 'At' or 'aT') The modem should respond with 'OK' on the screen. Themodem=s active parameters may be reviewed by using the AT&V command.

TESTING THE NETWORK

On the next system reboot the EXPNET.BAT file will start and attempt to log in to a network.

The THINCOM.EXE PC Card network adapter driver

- 7 -

Image 11

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary System Requirement IntroductionIntroduction Hardware Installation Guide InstallationInstallation Network Environment Driver selection Installation VerificationInstallation Testing the Network Installation Testing the ModemIf Something Goes Wrong Windows 95 InstallationInstall the Thincom Card Enabling 32-BIT Card Support in Windows Modem Installation VerificationNetwork Installation Data Communication Operation Operating Mode Operating ModeCellular Operation Remote AccessData Communication File TransferringFAX Operation FAX OperationPage Diagnostic Function DiagnosticNo Dial Tone TroubleshootingTroubleshooting Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link ECC Comands MNP 10 CommandsCaller ID Commands Enable MNP 10 extended services detection onlyCellular Commands Command Default Function Basic AT= command for 1414 CLDisabled QAM modulation only Is enabled when DTR is turned onConfigured. DTR option Hz guard tone enabledRange No Retrain ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function S37000 S90000 S108002 S109062Enable Bps rate adjusting Dial Modifiers Command Function Disables V.42 bisEnables V.42 bis only when transmitting data Enables V.42 bis only when receiving dataCommand Function Return the value of default S register ECC Commands Operating Consideration Function Range Units Register Summary Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Part FCC Compliance StatementsFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page