EXP Computer PCMCIA Ethernet Modem Adapter user manual Installation

Page 8

INSTALLATION

Make sure to match the cable connector=s color with the connector on the card. The Modem connector is keyed, and it can not be inserted to the Ethernet connector accidently.

5. Insert the LAN interface cable with RJ-45 connector into the LAN port(White connector). Push in the connector firmly.

Make sure to match the cable connector=s color with the connector on the card. The Ethernet connector is keyed, and it can not be inserted to the Modem connector accidently.

6.You are now ready to install the ThinCom=s Ethernet and Modem device driver. Please follow the Software Installation Guide procedures.

SOFTWARE INSTALLATION GUIDE for DOS/Windows 3.XX

Install the ThinCom=s driver with PC Card device driver

CMost of the notebook computer manufacturers supply the device driver program to operate the PC Card slot on their computers. The ThinCom=s driver work with the PC Card (Socket Service and Card Service) device driver compliant to the PCMCIA 2.1 or later specification. Check the table on the APPENDIX A for the name of some widely used device drivers.

CA minimum of 8K block of memory in the UMB (Upper Memory Block) should be available. In order to initialize and access the ThinCom card such a memory block exclusion is requied. In most case the PC Card device driver installation program will set the option in the EMM386.exe of the C:\config.sys file. The statement may look like this: (The actul setting for your computer may be different)

- 4 -

Image 8

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary Introduction System RequirementIntroduction Installation Hardware Installation GuideInstallation Installation Verification Network Environment Driver selectionInstallation Installation Testing the Modem Testing the NetworkIf Something Goes Wrong Windows 95 InstallationInstall the Thincom Card Enabling 32-BIT Card Support in Windows Installation Verification ModemNetwork Installation Data Communication Operation Operating Mode Operating ModeRemote Access Data CommunicationFile Transferring Cellular OperationFAX Operation FAX OperationPage Diagnostic Diagnostic FunctionNo Dial Tone TroubleshootingTroubleshooting Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link MNP 10 Commands ECC ComandsEnable MNP 10 extended services detection only Caller ID CommandsCellular Commands Basic AT= command for 1414 CL Command Default FunctionIs enabled when DTR is turned on Configured. DTR optionHz guard tone enabled Disabled QAM modulation onlyATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @ 42, MNP AT Commands Default FunctionS37000 S90000 S108002 S109062 Range No RetrainEnable Bps rate adjusting Disables V.42 bis Enables V.42 bis only when transmitting dataEnables V.42 bis only when receiving data Dial Modifiers Command FunctionCommand Function Return the value of default S register ECC Commands Operating Consideration Register Summary Function Range Units Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Compliance Statements FCC PartFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page