EXP Computer PCMCIA Ethernet Modem Adapter Enable MNP 10 extended services detection only

Page 31

APPENDIX A

-K0	Disable MNP 10 extended services.
-K1	Enable MNP 10 extended services.
-K2	Enable MNP 10 extended services detection only.
-Q0	Disable MNP 10 fallback to 2400 bps (V.22 bis)/1200 bps (V.22).
-Q1	Enable MNP 10 fallback to 2400 bps (V.22 bis)/1200 bps (V.22).
@M0	Select initial transmit level of -26 dBm.
@M1	Select initial transmit level of -30 dBm.
@M2	Select initial transmit level of -10 dBm.
@M3 - @M10	Select initial transmit level of -10 dBm.
@M11	Select initial transmit level of -11 dBm.
@M12	-Select initial transmit level of -12 dBm.
.
.
.
@M30	Select initial transmit level of -30 dBm.
@M31	Select initial transmit level of -31 dBm.
:E0	Disable the compromise equalizer.
:E1	Enable the compromise equalizer.
CALLER ID COMMANDS
#CID=0	Disable Caller ID.
#CID=1	Enable Caller ID with formatted presentation.
#CID=2	Enable Caller ID with unformatted presentation.

- 27 -

Image 31

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary System Requirement IntroductionIntroduction Hardware Installation Guide InstallationInstallation Network Environment Driver selection Installation VerificationInstallation Testing the Network Installation Testing the ModemInstall the Thincom Card Windows 95 InstallationIf Something Goes Wrong Enabling 32-BIT Card Support in Windows Modem Installation VerificationNetwork Installation Data Communication Operation Operating Mode Operating ModeCellular Operation Remote AccessData Communication File TransferringFAX Operation FAX OperationPage Diagnostic Function DiagnosticTroubleshooting TroubleshootingNo Dial Tone Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link ECC Comands MNP 10 CommandsCaller ID Commands Enable MNP 10 extended services detection onlyCellular Commands Command Default Function Basic AT= command for 1414 CLDisabled QAM modulation only Is enabled when DTR is turned onConfigured. DTR option Hz guard tone enabledRange No Retrain ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function S37000 S90000 S108002 S109062Enable Bps rate adjusting Dial Modifiers Command Function Disables V.42 bisEnables V.42 bis only when transmitting data Enables V.42 bis only when receiving dataCommand Function Return the value of default S register ECC Commands Operating Consideration Function Range Units Register Summary Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Part FCC Compliance StatementsFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page