EXP Computer PCMCIA Ethernet Modem Adapter user manual Operating Consideration

Page 41

EXP Fax/Data Modem

OPERATING CONSIDERATION

MNP 10 COMMANDS (14.400 modem only)

)M0

Disable MNP 10 link negotiation power adjustment.

)M1

Enable MNP 10 link negotiation power adjustment.

*H0

Select MNP 10 link negotiation at highest rate.

*H1

Select MNP 10 link negotiation at 1200 bps.

*H2

Select MNP 10 link negotiation at 4800 bps.

-K0

Disable MNP 10 extended services.

-K1

Enable MNP 10 extended services.

-K2

Enable MNP 10 extended services detection only.

-Q0

Disable MNP 10 fallback to 2400 bps (V.22 bis)/1200 bps (V.22).

-Q1

Enable MNP 10 fallback to 2400 bps (V.22 bis)/1200 bps (V.22).

@M0

Select initial transmit level of -26 dBm.

@M1

Select initial transmit level of -30 dBm.

@M2

Select initial transmit level of -10 dBm.

@M3 - @M10

Select initial transmit level of -10 dBm.

@M11

Select initial transmit level of -11 dBm.

@M12

Select initial transmit level of -12 dBm.

.

 

.

 

.

 

@M30

Select initial transmit level of -30 dBm.

@M31

Select initial transmit level of -31 dBm.

:E0

Disable the compromise equalizer.

:E1

Enable the compromise equalizer.

- 37 -

Page 40 Page 42
Image 41
Page 40 Page 42
Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary System Requirement IntroductionIntroduction Hardware Installation Guide InstallationInstallation Network Environment Driver selection Installation VerificationInstallation Testing the Network Installation Testing the ModemIf Something Goes Wrong Windows 95 InstallationInstall the Thincom Card Enabling 32-BIT Card Support in Windows Modem Installation VerificationNetwork Installation Data Communication Operation Operating Mode Operating ModeData Communication Remote AccessFile Transferring Cellular OperationFAX Operation FAX OperationPage Diagnostic Function DiagnosticNo Dial Tone TroubleshootingTroubleshooting Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link ECC Comands MNP 10 CommandsCaller ID Commands Enable MNP 10 extended services detection onlyCellular Commands Command Default Function Basic AT= command for 1414 CLConfigured. DTR option Is enabled when DTR is turned onHz guard tone enabled Disabled QAM modulation only42, MNP AT Commands Default Function ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @S37000 S90000 S108002 S109062 Range No RetrainEnable Bps rate adjusting Enables V.42 bis only when transmitting data Disables V.42 bisEnables V.42 bis only when receiving data Dial Modifiers Command FunctionCommand Function Return the value of default S register ECC Commands Operating Consideration Function Range Units Register Summary Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Part FCC Compliance StatementsFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page
Top Page Image Contents