EXP Computer PCMCIA Ethernet Modem Adapter user manual CS.EXE Pcmcs Ctalkcs

Page 25

TROUBLESHOOTING

The name of device drivers for the major PC Card software vendors are listed below:

Software/Device	SystemSoft	Phoenix	Databook
Driver	CardSoft		Cardtalk
Socket Services	SS365SL.EX	PCMSS.	SNOTEP
	E,	EXE	V2.SYS
	SS365LP.EX
	E,
	SSCIRRUS.
	EXE,
	SSDBOOK.E
	XE,
	SVADEM.EX
	E,
	SSVLSI.EXE
Card Services	CS.EXE	PCMCS.	CTALKCS
		EXE	.EXE
Resource	CSALLOC.E	PCMRM
Initialization	XE	AN.SYS
Utility
IDE/ATA Driver	S_IDE.EXE	PCMATA
	or	.SYS
	ATADRV.EX
	E
SRAM Card	SRAMDRV.E
Driver	XE or
	MTSRAM.EX
	E
Flash Card	MTAA.EXE,
Support	MTAB.EXE,
	MTAB.EXE,
	MTI1,EXE
	MTI2P.EXE
Memory Card	SCARD29.E
Driver	XE or
	MEMDRV.E
	XE
Card Installation	CIC.EXE or	PCMSC	CARDTAL
Utility	CARDID.EX	D.EXE	K.SYS
	CARDID.EX
	E

- 21 -

Image 25

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary System Requirement IntroductionIntroduction Hardware Installation Guide InstallationInstallation Network Environment Driver selection Installation VerificationInstallation Testing the Network Installation Testing the ModemInstall the Thincom Card Windows 95 InstallationIf Something Goes Wrong Enabling 32-BIT Card Support in Windows Modem Installation VerificationNetwork Installation Data Communication Operation Operating Mode Operating ModeData Communication Remote AccessFile Transferring Cellular OperationFAX Operation FAX OperationPage Diagnostic Function DiagnosticTroubleshooting TroubleshootingNo Dial Tone Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link ECC Comands MNP 10 CommandsCaller ID Commands Enable MNP 10 extended services detection onlyCellular Commands Command Default Function Basic AT= command for 1414 CLConfigured. DTR option Is enabled when DTR is turned onHz guard tone enabled Disabled QAM modulation only42, MNP AT Commands Default Function ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @S37000 S90000 S108002 S109062 Range No RetrainEnable Bps rate adjusting Enables V.42 bis only when transmitting data Disables V.42 bisEnables V.42 bis only when receiving data Dial Modifiers Command FunctionCommand Function Return the value of default S register ECC Commands Operating Consideration Function Range Units Register Summary Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Part FCC Compliance StatementsFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page