EXP Computer PCMCIA Ethernet Modem Adapter user manual Introduction

Page 6

INTRODUCTION

The system should have at least one Type II or Type III (5.0 mm or 10.0 mm thickness) slot.

2. DOS version 5.0 or higher

Or

Windows 95

3.Socket Service and Card Service compliant with PCMCIA 2.10 to operate the PC Card (PCMCIA ) slot.

Normally, the device driver is pre-installed on the computer from the factory.

4.Network operating system software compatible with NDIS or ODI drivers.

5.A RJ-45 (10 Base-T) jack connect to a network server or a computer.

6.A working analog telephone line

- 2 -

Image 6

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary Introduction System RequirementIntroduction Installation Hardware Installation GuideInstallation Installation Verification Network Environment Driver selectionInstallation Installation Testing the Modem Testing the NetworkWindows 95 Installation Install the Thincom CardIf Something Goes Wrong Enabling 32-BIT Card Support in Windows Installation Verification ModemNetwork Installation Data Communication Operation Operating Mode Operating ModeFile Transferring Remote AccessData Communication Cellular OperationFAX Operation FAX OperationPage Diagnostic Diagnostic FunctionTroubleshooting TroubleshootingNo Dial Tone Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link MNP 10 Commands ECC ComandsEnable MNP 10 extended services detection only Caller ID CommandsCellular Commands Basic AT= command for 1414 CL Command Default FunctionHz guard tone enabled Is enabled when DTR is turned onConfigured. DTR option Disabled QAM modulation onlyS37000 S90000 S108002 S109062 ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function Range No RetrainEnable Bps rate adjusting Enables V.42 bis only when receiving data Disables V.42 bisEnables V.42 bis only when transmitting data Dial Modifiers Command FunctionCommand Function Return the value of default S register ECC Commands Operating Consideration Register Summary Function Range Units Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Compliance Statements FCC PartFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page