EXP Computer PCMCIA Ethernet Modem Adapter user manual Installation Verification

Page 14

INSTALLATION

INSTALLATION VERIFICATION Cont.

MODEM

Windows 95

After installation, you may wish to check if the computer recognized the modem and the assigned COM port.

1.Click on Start => Settings => Control Panel => Modem => Diagnostics tab.

2.Locate the modem*s COM port then highlight it. Click on >More Info...* button.

3.The Windows 95 will try to communicate with the modem. The More Info... window appear with all the modem identification information. (Your actual display may be different)

The ThinCom modem portion is installed properly and ready to use.

- 10 -

Image 14

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary Introduction System RequirementIntroduction Installation Hardware Installation GuideInstallation Installation Verification Network Environment Driver selectionInstallation Installation Testing the Modem Testing the NetworkIf Something Goes Wrong Windows 95 InstallationInstall the Thincom Card Enabling 32-BIT Card Support in Windows Installation Verification ModemNetwork Installation Data Communication Operation Operating Mode Operating ModeFile Transferring Remote AccessData Communication Cellular OperationFAX Operation FAX OperationPage Diagnostic Diagnostic FunctionNo Dial Tone TroubleshootingTroubleshooting Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link MNP 10 Commands ECC ComandsEnable MNP 10 extended services detection only Caller ID CommandsCellular Commands Basic AT= command for 1414 CL Command Default FunctionHz guard tone enabled Is enabled when DTR is turned onConfigured. DTR option Disabled QAM modulation onlyS37000 S90000 S108002 S109062 ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function Range No RetrainEnable Bps rate adjusting Enables V.42 bis only when receiving data Disables V.42 bisEnables V.42 bis only when transmitting data Dial Modifiers Command FunctionCommand Function Return the value of default S register ECC Commands Operating Consideration Register Summary Function Range Units Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Compliance Statements FCC PartFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page