EXP Computer PCMCIA Ethernet Modem Adapter user manual Copyright

Page 2

Copyright 1996

Revision 1.0

September 6, 1996

ALL trademarks and registered trademark are of their respective companies.

No part of this publication may be reproduced, stored in a retrieval or transmitted in any form or by any means, mechanically, photocopying, or recording.

The information in this publication has been carefully checked and is believed to be accurate as of its publication date. EXP will not be held reponsible for any inadvertent.

All information is subject to change without notice.

- ii -

Image 2

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary Introduction System RequirementIntroduction Installation Hardware Installation GuideInstallation Installation Verification Network Environment Driver selectionInstallation Installation Testing the Modem Testing the NetworkIf Something Goes Wrong Windows 95 InstallationInstall the Thincom Card Enabling 32-BIT Card Support in Windows Installation Verification ModemNetwork Installation Data Communication Operation Operating Mode Operating ModeFile Transferring Remote AccessData Communication Cellular OperationFAX Operation FAX OperationPage Diagnostic Diagnostic FunctionNo Dial Tone TroubleshootingTroubleshooting Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link MNP 10 Commands ECC ComandsEnable MNP 10 extended services detection only Caller ID CommandsCellular Commands Basic AT= command for 1414 CL Command Default FunctionHz guard tone enabled Is enabled when DTR is turned onConfigured. DTR option Disabled QAM modulation onlyS37000 S90000 S108002 S109062 ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function Range No RetrainEnable Bps rate adjusting Enables V.42 bis only when receiving data Disables V.42 bisEnables V.42 bis only when transmitting data Dial Modifiers Command FunctionCommand Function Return the value of default S register ECC Commands Operating Consideration Register Summary Function Range Units Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Compliance Statements FCC PartFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page