EXP Computer PCMCIA Ethernet Modem Adapter user manual Table of Contents

Page 3

	TABLE OF CONTENTS
INTRODUCTION
Features and Compatibility	1
REQUIREMENTS
Notebook computer with PC Card slot	2
PC Card device driver	2
Upper Memory Block Region	2
Analog Telephone line	2
INSTALLATION
Hardware Installation	5
Software Installation	7
Diagnose the need for PC Card (PCMCIA 2.10) software		support.7
Installing the PointEnabler Device Driver	9
Installing the PointEnabler Device Driver on an unlisted		Host PC.	10
Installation Verification	11	Windows 95 Installation for Modem		12
Enabling 32-bit card support of Windows 95	13
Modem Selection	15
DATA COMMUNICATION	15
Operating Mode	17
CELLULAR OPERATION	19
FAX OPERATION	20
DIAGNOSTIC FUNCTION	21
TROUBLE SHOOTING	23
APPENDIX A
AT Commands for 28,800	24
AT Command for 1414CL	31

TABLE OF CONTENTS (Cont.)

- iii -

Image 3

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary System Requirement IntroductionIntroduction Hardware Installation Guide InstallationInstallation Network Environment Driver selection Installation VerificationInstallation Testing the Network Installation Testing the ModemWindows 95 Installation Install the Thincom CardIf Something Goes Wrong Enabling 32-BIT Card Support in Windows Modem Installation VerificationNetwork Installation Data Communication Operation Operating Mode Operating ModeCellular Operation Remote AccessData Communication File TransferringFAX Operation FAX OperationPage Diagnostic Function DiagnosticTroubleshooting TroubleshootingNo Dial Tone Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link ECC Comands MNP 10 CommandsCaller ID Commands Enable MNP 10 extended services detection onlyCellular Commands Command Default Function Basic AT= command for 1414 CLDisabled QAM modulation only Is enabled when DTR is turned onConfigured. DTR option Hz guard tone enabledRange No Retrain ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function S37000 S90000 S108002 S109062Enable Bps rate adjusting Dial Modifiers Command Function Disables V.42 bisEnables V.42 bis only when transmitting data Enables V.42 bis only when receiving dataCommand Function Return the value of default S register ECC Commands Operating Consideration Function Range Units Register Summary Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Part FCC Compliance StatementsFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page