EXP Computer PCMCIA Ethernet Modem Adapter user manual Function Range

Page 43

						APPENDIX B


	S13	Reserved	-	-	-
	S14	General Bit Mapped Options	-	-	*		138 (8Ah)
	S15	Reserved	-	-	-		-
	S16	Test Mode Bit Mapped	-	-			0
		Options(&T)
	S17	Reserved	-	-			-
	S18	Test Timer	0-225	s	*		0
	S19	AutoSync Bit-Mapped Options	-	-	-		-
	S20	HDLC address or BSC sync	0-255	ASCII	-		-
		character
	S21	V.24/General Bit Mapped	-	-	-		4(04h)
		Options
	S22	Speaker/Results Bit Mapped	-	-	*		117(75h)
		Options
	S23	General Bit Mapped Options		-	*		55(37h)

	S24	Sleep Inactivity Timer	0-255	s			0
	S25	Delay to DTR Off	0-255	s or			5
				0.01s
	S26	RTS-to-CTS Delay	0-255	0.01s			1
	S27	General Bit Mapped Option	-	-	*		73(49h) w/ ECC
							74(4Ah)w/o ECC
	S28	General Bit-Mapped Options	-	-	*		0
	S29	Flash Dial Modifier Time	0-255	10 ms			0
	S30	Disconnect Inactivity Timer	0-255	10s			0
	S31	General Bit-Mapped Options	-	-	*		2

	S32	XON Character	0-255	ASCII			17 (11h)

	Register	Function	Range	Units	Save		Default

- 39 -

Image 43

Contents ThinCom Pcmcia Ethernet Modem Adapter User=s Manual Copyright Table of Contents Register Summary System Requirement IntroductionIntroduction Hardware Installation Guide InstallationInstallation Network Environment Driver selection Installation VerificationInstallation Testing the Network Installation Testing the ModemInstall the Thincom Card Windows 95 InstallationIf Something Goes Wrong Enabling 32-BIT Card Support in Windows Modem Installation VerificationNetwork Installation Data Communication Operation Operating Mode Operating ModeCellular Operation Remote AccessData Communication File TransferringFAX Operation FAX OperationPage Diagnostic Function DiagnosticTroubleshooting TroubleshootingNo Dial Tone Appendix a CS.EXE Pcmcs Ctalkcs Basic AT= command for 28,800 Modem Command Function Appendix a Set 10 pps pulse dial with 39%/61% make/break Modem negotiates an error corrected link ECC Comands MNP 10 CommandsCaller ID Commands Enable MNP 10 extended services detection onlyCellular Commands Command Default Function Basic AT= command for 1414 CLDisabled QAM modulation only Is enabled when DTR is turned onConfigured. DTR option Hz guard tone enabledRange No Retrain ATDS=n command = 0, 9, A, B, C, D, #, *, T, P, R, W, @42, MNP AT Commands Default Function S37000 S90000 S108002 S109062Enable Bps rate adjusting Dial Modifiers Command Function Disables V.42 bisEnables V.42 bis only when transmitting data Enables V.42 bis only when receiving dataCommand Function Return the value of default S register ECC Commands Operating Consideration Function Range Units Register Summary Function Range UnitsFunction Range S33 Xoff Character 255 Appendix B Page FCC Part FCC Compliance StatementsFCC Consumer Information and FCC Requirements Canadian Department of Communications compliance statements Page