EXP Computer PCMCIA Ethernet Modem Adapter S37000 S90000 S108002 S109062, Range No Retrain

APPENDIX A

S37:000 S90:000 S108:002 S109:062

Telephone Numbers: &Z0 12345

&Z1 T4444444 &Z2 T12345

&Z3 T 1 (123) 456-7890

&W	0	Store active profile in user profile 0
	1	Store in active profile user profile 1
&Y	0*	Select stored profile 0 on power up
	1	Select stored profile 1 on power up
&Zn=x	none	Store telephone number
		To dial the stored telephone, use the
		ATDS=n command.
		x = 0, 9, A, B, C, D, #, *, T, P, R, W, @, ,,!,;
		n = 0-3
%E	0	Disable Auto-retrain ( V.32 and V.32bis Only)
	1 *	Enable Auto-retrain
%G0	0 *	Disable Auto Fallforward/fallback Rate	Renegotiation
	1	Enable Auto Fallforward/fallback Rate	Renegotiation
%Q	none	Line signal quality
		Range: 0-255
		0 - 7 No Retrain	8 - 255 Modem performs a Retrain (i.e., if configured for %E1)
-Cn	0*	Diable data modem calling tone
	1	Enable data modem calling tone

*Value saved in NVRAM.

V.42, MNP 'AT' Commands
Command	Default	Function
%A	13	Set auto-reliable fallback character
%C	0	No data compression
	1*	MNP 5 data compression control
\A	0	MNP block size Maximum 64 characters
	1	MNP block size Maximum 128 characters
	2	MNP block size Maximum 192 characters
	3*	MNP block size Maximum 256 characters
\Bn	none	Transmit break (n=0-9 Break lenght in 100 msec)
\C	0*	Does not buffer data
	1	Buffers data for four seconds until 200 characters have been buffered or SYN character is detected, then switches to reliable mode. If the buffer fills,
		data is passed to the serial port.
	2	Does not buffer data. Switches to normal mode upon receipt of auto-reliable fallback character and passes it to serial port. This feature is used to
		allow non-V.42 modems to connect immediately to a V.42 modem without data loss. Set auto-reliable buffer
\G	0 *	Disable modem port flow control
	1	Set port flow control to XON/XOFF
\Jn	0 *	Disable Bps rate adjusting

- 31 -