Accton Technology ES3528M-SFP manual Quality of Service Commands

4 Command Line Interface

Example

Console#show map ip dscp ethernet 1/1

DSCP mapping status: disabled

Port	DSCP COS
--------- ---- ---
Eth 1/ 1	0	0
Eth 1/ 1	1	0
Eth 1/ 1	2	0
. Eth 1/ 1	3	0
.
.	61	0
Eth 1/ 1
Eth 1/ 1	62	0
Eth 1/ 1	63	0
Console#

Related Commands

map ip dscp (Global Configuration) (4-269) map ip dscp (Interface Configuration) (4-270)

Quality of Service Commands

The commands described in this section are used to configure Differentiated Services (DiffServ) classification criteria and service policies. You can classify traffic based on access lists, IP Precedence or DSCP values, or VLANs. Using access lists allows you select traffic based on Layer 2, Layer 3, or Layer 4 information contained in each packet.

Table 4-72 Quality of Service Commands

Command	Function	Mode	Page
class-map	Creates a class map for a type of traffic	GC	4-273
match	Defines the criteria used to classify traffic	CM	4-274
policy-map	Creates a policy map for multiple interfaces	GC	4-275
class	Defines a traffic classification for the policy to act on	PM	4-276
set	Classifies IP traffic by setting a CoS, DSCP, or IP-precedence	PM-C	4-277
	value in a packet
police	Defines an enforcer for classified traffic	PM-C	4-277
service-policy	Applies a policy map defined by the policy-mapcommand to	IC	4-278
	the input of a particular interface
show class-map	Displays the QoS class maps which define matching criteria	PE	4-279
	used for classifying traffic
show policy-map	Displays the QoS policy maps which define classification	PE	4-279
	criteria for incoming traffic, and may include policers for
	bandwidth limitations
show policy-map interface	Displays the configuration of all classes configured for all	PE	4-280
	service policies on the specified interface

4-272