Accton Technology ES3528M-SFP manual Configuring the Switch

RADIUS server

1. Client attempts to access a switch port.

2. Switch sends client an identity request.

3. Client sends back identity information.

4. Switch forwards this to authentication server.

5. Authentication server challenges client.

6. Client responds with proper credentials.

7. Authentication server approves access.

8. Switch grants client access to this port.

802.1x client

3 Configuring the Switch

This switch uses the Extensible Authentication Protocol over LANs (EAPOL) to exchange authentication

protocol messages with the client, and a remote RADIUS authentication server to verify

user identity and access rights. When a client (i.e., Supplicant) connects to a switch port, the switch (i.e.,

Authenticator) responds with an EAPOL identity request. The client provides its identity (such as a user name) in an EAPOL response to the switch, which it forwards to the RADIUS server. The RADIUS server verifies the client identity and sends an access challenge back to the client. The EAP packet from the RADIUS server contains not only the challenge, but the authentication method to be used. The client can reject the authentication method and request another, depending on the configuration of the client software and the RADIUS server. The encryption method used to pass authentication messages can be MD5 (Message-Digest 5), TLS (Transport Layer Security), PEAP (Protected Extensible Authentication Protocol), or TTLS (Tunneled Transport Layer Security). The client responds to the appropriate method with its credentials, such as a password or certificate. The RADIUS server verifies the client credentials and responds with an accept or reject packet. If authentication is successful, the switch allows the client to access the network. Otherwise, non-EAP traffic on the port is blocked or assigned to a guest VLAN based on the “intrusion-action” setting. In “multi-host” mode, only one host connected to a port needs to pass authentication for all other hosts to be granted network access. Similarly, a port can become unauthorized for all hosts if one attached host fails re-authentication or sends an EAPOL logoff message.

The operation of 802.1X on the switch requires the following:

•The switch must have an IP address assigned.

•RADIUS authentication must be enabled on the switch and the IP address of the RADIUS server specified.

•802.1X must be enabled globally for the switch.

•Each switch port that will be used must be set to dot1X “Auto” mode.

•Each client that needs to be authenticated must have dot1X client software installed and properly configured.

•The RADIUS server and 802.1X client support EAP. (The switch only supports EAPOL in order to pass the EAP packets from the server to the client.)

•The RADIUS server and client also have to support the same EAP authentication type – MD5, PEAP, TLS, or TTLS. (Some clients have native support in the operating system, otherwise the dot1x client must support the required authentication method.)

3-82