Accton Technology ES3528M-SFP manual IP Cluster Commands, Show ip dhcp snooping binding

4 Command Line Interface

show ip dhcp snooping binding

This command shows the DHCP snooping binding table entries.

Command Mode

Privileged Exec

Example

Console#show ip dhcp snooping binding
MacAddress	IpAddress	Lease(sec)	Type	VLAN	Interface
-----------------	--------------- ----------		-------------------- ----		---------
11-22-33-44-55-66	192.168.0.99	0	Static	1	Eth 1/5
Console#

IP Cluster Commands

IP Clustering is a method of grouping switches together to enable centralized management through a single unit. A switch cluster has a “Commander” unit that is used to manage all other “Member” switches in the cluster. The management station uses Telnet to communicate directly with the Commander throught its IP address, and the Commander manages Member switches using cluster “internal” IP addresses. There can be up to 36 Member switches in one cluster. Cluster switches are limited to within a single IP subnet.

Table 4-86 Switch Cluster Commands

Command	Function	Mode	Page
cluster	Configures clustering on the switch	GC	4-324
cluster commander	Configures the switch as a cluster Commander	GC	4-325
cluster ip-pool	Sets the cluster IP address pool for Members	GC	4-326
cluster member	Sets Candidate switches as cluster members	GC	4-326
rcommand	Provides configuration access to Member switches	GC	4-327
show cluster	Displays the switch clustering status	PE	4-327
show cluster members	Displays current cluster Members	PE	4-328
show cluster candidates	Displays current cluster Candidates in the network	PE	4-328

cluster

This command enables clustering on the switch. Use the no form to disable clustering.

Syntax

[no] cluster

Default Setting

Enabled

Command Mode

Global Configuration

4-324