Accton Technology ES3528M-SFP manual Simple Mail Transfer Protocol, Remote Logs

Basic Configuration 3

Web – Click System, Log, Remote Logs. To add an IP address to the Host IP List, type the new IP address in the Host IP Address box, and then click Add. To delete an IP address, click the entry in the Host IP List, and then click Remove.

Figure 3-18 Remote Logs

CLI – Enter the syslog server host IP address, choose the facility type and set the logging trap.

Console(config)#logging host 192.168.1.15		4-57
Console(config)#logging facility 23		4-57
Console(config)#logging trap 4		4-58
Console(config)#end
Console#show logging trap	Enabled	4-58
Syslog logging:
REMOTELOG status:	Enabled
REMOTELOG facility type:	local use 7
REMOTELOG level type:	Warning conditions

REMOTELOG server ip address: 192.168.1.15

REMOTELOG server ip address: 0.0.0.0

REMOTELOG server ip address: 0.0.0.0

REMOTELOG server ip address: 0.0.0.0

REMOTELOG server ip address: 0.0.0.0

Console#

Simple Mail Transfer Protocol

SMTP (Simple Mail Transfer Protocol) is used to send email messages between servers. The messages can be retrieved using POP or IMAP clients.

Command Attributes

•Admin Status – Enables/disables the SMTP function. (Default: Enabled)

•Email Source Address – This command specifies SMTP servers email addresses that can send alert messages.

•Severity – Specifies the degree of urgency that the message carries.

3-31