Accton Technology ES3528M-SFP manual Garp timer, Show garp timer

VLAN Commands 4

garp timer

This command sets the values for the join, leave and leaveall timers. Use the no form to restore the timers’ default values.

Syntax

garp timer {join leave leaveall} timer_value no garp timer {join leave leaveall}

•{join leave leaveall} - Which timer to set.

•timer_value - Value of timer. Ranges:

join: 20-1000 centiseconds

leave: 60-3000 centiseconds

leaveall: 500-18000 centiseconds

Default Setting

•join: 20 centiseconds

•leave: 60 centiseconds

•leaveall: 1000 centiseconds

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

•Group Address Registration Protocol is used by GVRP and GMRP to register or deregister client attributes for client services within a bridged LAN. The default values for the GARP timers are independent of the media access method or data rate. These values should not be changed unless you are experiencing difficulties with GMRP or GVRP registration/deregistration.

•Timer values are applied to GVRP for all the ports on all VLANs.

•Timer values must meet the following restrictions:

-leave >= (2 x join)

-leaveall > leave

Note: Set GVRP timers on all Layer 2 devices connected in the same network to

the same values. Otherwise, GVRP may not operate successfully.

Example

Console(config)#interface ethernet 1/1

Console(config-if)#garp timer join 100

Console(config-if)#

Related Commands

show garp timer (4-241)

show garp timer

This command shows the GARP timers for the selected interface.

4-241