Accton Technology ES3528M-SFP Interface Commands Function Mode, Port-channel channel-idRange

4 Command Line Interface

Interface Commands

These commands are used to display or set communication parameters for an Ethernet port, aggregated link, or VLAN.

Table 4-47 Interface Commands

Command	Function	Mode	Page
interface	Configures an interface type and enters interface configuration	GC	4-166
	mode
description	Adds a description to an interface configuration	IC	4-167
speed-duplex	Configures the speed and duplex operation of a given interface	IC	4-167
	when autonegotiation is disabled
negotiation	Enables autonegotiation of a given interface	IC	4-168
capabilities	Advertises the capabilities of a given interface for use in	IC	4-169
	autonegotiation
flowcontrol	Enables flow control on a given interface	IC	4-170
shutdown	Disables an interface	IC	4-171
switchport packet-rate	Configures the broadcast storm control threshold	IC	4-172
clear counters	Clears statistics on an interface	PE	4-172
show interfaces status	Displays status for the specified interface	NE, PE	4-173
show interfaces	Displays statistics for the specified interfaces	NE, PE	4-174
counters
show interfaces	Displays the administrative and operational status of an	NE, PE	4-175
switchport	interface

interface

This command configures an interface type and enters interface configuration mode. Use the no form to remove a trunk.

Syntax

interface interface

no interface port-channel channel-id

interface

•ethernet unit/port

-unit - Stack unit. (Range: 1)

-port - Port number. (Range: 1-28)

•port-channel channel-id(Range: 1-8)

•vlan vlan-id(Range: 1-4092)

Default Setting

None

Command Mode

Global Configuration

4-166