Accton Technology ES3528M-SFP manual Setting the System Clock, Setting the Time Manually

3 Configuring the Switch

CLI – Use the reload command to restart the switch. When prompted, confirm that you want to reset the switch.

Console#reload	4-24
System will be	restarted, continue <y/n>? y

Note: When restarting the system, it will always run the Power-On Self-Test. It will also retain all configuration information stored in non-volatile memory (See “Saving or Restoring Configuration Settings” on page 3-21or the copy running-configstartup-configcommand (See “copy” on page 4-85)).

Setting the System Clock

Simple Network Time Protocol (SNTP) allows the switch to set its internal clock based on periodic updates from a time server (SNTP or NTP). Maintaining an accurate time on the switch enables the system log to record meaningful dates and times for event entries. You can also manually set the clock. If the clock is not set, the switch will only record the time from the factory default set at the last bootup.

When the SNTP client is enabled, the switch periodically sends a request for a time update to a configured time server. You can configure up to three time server IP addresses. The switch will attempt to poll each server in the configured sequence.

Setting the Time Manually

You can set the system time on the switch manually without using SNTP.

CLI – This example sets the system clock time and then displays the current time and date.

Console#calendar set	17 46 00 october 18 2007	4-77
Console#show calendar		4-77
17:46:11 October 18	2007
Console#

Configuring SNTP

You can configure the switch to send time synchronization requests to time servers.

Command Attributes

•SNTP Client – Configures the switch to operate as an SNTP client. This requires at least one time server to be specified in the SNTP Server field. (Default: Disabled)

•SNTP Poll Interval – Sets the interval between sending requests for a time update from a time server. (Range: 16-16384 seconds; Default: 16 seconds)

•SNTP Server – Sets the IP address for up to three time servers. The switch attempts to update the time from the first server, if this fails it attempts an update from the next server in the sequence.

Web – Select SNTP, Configuration. Modify any of the required SNTP parameters, and click Apply.

3-34