Accton Technology ES3528M-SFP manual Protocol VLANs, Protocol Vlan Group Configuration, 257, 258

VLAN Configuration 3

Web – Click VLAN, Private VLAN, Port Configuration or Trunk Configuration. Set the PVLAN Port Type for each port that will join a private VLAN. Assign promiscuous ports to a primary VLAN. Assign host ports to a community VLAN. After all the ports have been configured, click Apply.

Figure 3-107 Private VLAN Port Configuration

CLI – This example shows the switch configured with primary VLAN 5 and secondary VLAN 6. Port 3 has been configured as a promiscuous port and mapped to VLAN 5, while ports 4 and 5 have been configured as a host ports and associated with VLAN 6. This means that traffic for port 4 and 5 can only pass through port 3.

Console(config)#interface ethernet	1/3
Console(config-if)#switchport mode	private-vlan promiscuous	4-257
Console(config-if)#switchport private-vlan mapping 5		4-259
Console(config-if)#exit	1/4
Console(config)#interface ethernet
Console(config-if)#switchport mode	private-vlan host	4-257
Console(config-if)#switchport private-vlan host-association 6		4-258
Console(config-if)#exit	1/5
Console(config)#interface ethernet
Console(config-if)#switchport mode	private-vlan host

Console(config-if)#switchport private-vlan host-association 6 Console(config-if)#

Protocol VLANs

You can configure VLAN behavior to support multiple protocols to allow traffic to pass through different VLANs. When a packet is received at a port, its VLAN membership is determined by the protocol type of the packet.

Protocol VLAN Group Configuration

Command Attributes

•Protocol Group ID – Protocol Group ID assigned to the Protocol VLAN Group. (Range: 1-2147483647)

3-179