Accton Technology ES3528M-SFP manual Configuring Private Vlan Interfaces, 259

3 Configuring the Switch

CLI – This example shows the switch configured with primary VLAN 5 and community VLAN 6. Port 3 has been configured as a promiscuous port and mapped to VLAN 5, while ports 4 and 5 have been configured as host ports and associated with VLAN 6. This means that traffic for port 4 and 5 can only pass through port 3.

Console#show vlan private-vlan			4-259
Primary	Secondary	Type	Interfaces
--------	-----------	----------	------------------------------
5	6	primary	Eth1/ 3
5		community	Eth1/ 4 Eth1/ 5
Console#

Configuring Private VLAN Interfaces

Use the Private VLAN Port Configuration and Private VLAN Trunk Configuration menus to set the private VLAN interface type, and assign the interfaces to a private VLAN.

Command Attributes

•Port/Trunk – The switch interface.

•PVLAN Port Type – Sets the private VLAN port types.

-Normal – The port is not assigned to a private VLAN.

-Host – The port is a community port or an isolated port. A community port can communicate with other ports in its own community VLAN and with designated promiscuous port(s). An isolated port can only communicate with the single designated promiscuous port in the isolated VLAN; it cannot communicate with any other host ports.

-Promiscuous – A promiscuous port can communicate with all interfaces within a private VLAN.

•Primary VLAN – Conveys traffic between promiscuous ports, and between promiscuous ports and community ports within the associated secondary VLANs. If PVLAN type is “Promiscuous,” then specify the associated primary VLAN.

•Community VLAN – A community VLAN conveys traffic between community ports, and from community ports to their designated promiscuous ports. Set PVLAN Port Type to “Host,” and then specify the associated Community VLAN.

•Trunk – The trunk identifier. (Port Information only)

3-178