Link Layer Discovery Protocol

3-183

3
critical to the timely startup of LLDP, and therefore integral to the rapid availability
of Emergency Call Service.
Web – Click LLDP, Configuration. Enable LLDP, modify any of the timing parameters
as required, and click Apply.
Figure 3-110 LLDP Configuration
CLI – This example sets several attributes which control basic LLDP message
timing.
Configuring LLDP Interface Attributes
Use the LLDP Port/Trunk Configuration to specify the message attributes for
individual interfaces, including whether messages are transmitted, received , or both
transmitted and received, whether SNMP notifications are sent, and the type of
information advertised.
Console(config)#lldp 4-195
Console(config)#lldp refresh-interval 60 4-197
Console(config)#lldp holdtime-multiplier 10 4-195
Console(config)#lldp tx-delay 10 4-198
Console(config)#lldp reinit-delay 10 4-198
Console(config)#lldp notification-interval 30 4-196
Console(config)#lldp medFastStartCount 6 4-196
Console(config)#exit
Console#show lldp config
LLDP Global Configuation
LLDP Enable : Yes
LLDP Transmit interval : 60
LLDP Hold Time Multiplier : 10
LLDP Delay Interval : 10
LLDP Reinit Delay : 10
LLDP Notification Interval : 30
.
.
.