Accton Technology ES3528M-SFP manual Policy-map, No policy-mappolicy-map-name

Quality of Service Commands 4

This example creates a class map call “rd_class#2,” and sets it to match packets marked for IP Precedence service value 5:

Console(config)#class-map rd_class#2 match-any

Console(config-cmap)#match ip precedence 5

Console(config-cmap)#

This example creates a class map call “rd_class#3,” and sets it to match packets marked for VLAN 1:

Console(config)#class-map rd_class#3 match-any

Console(config-cmap)#match vlan 1

Console(config-cmap)#

policy-map

This command creates a policy map that can be attached to multiple interfaces, and enters Policy Map configuration mode. Use the no form to delete a policy map and return to Global configuration mode.

Syntax

[no] policy-mappolicy-map-name

policy-map-name- Name of the policy map. (Range: 1-16 characters)

Default Setting

None

Command Mode

Global Configuration

Command Usage

•Use the policy-mapcommand to specify the name of the policy map, and then use the class command to configure policies for traffic that matches criteria defined in a class map.

•A policy map can contain multiple class statements that can be applied to the same interface with the service-policycommand (page 4-278).

•You must create a Class Map (page 4-275)before assigning it to a Policy Map.

Example

This example creates a policy called “rd_policy,” uses the class command to specify the previously defined “rd_class,” uses the set command to classify the service that incoming packets will receive, and then uses the police command to limit the average bandwidth to 100,000 Kbps, the burst rate to 1522 bytes, and configure the response to drop any violating packets.

Console(config)#policy-map rd_policy Console(config-pmap)#class rd_class Console(config-pmap-c)#set ip dscp 3 Console(config-pmap-c)#police 100000 1522 exceed-action drop Console(config-pmap-c)#

4-275