Accton Technology ES3528M-SFP manual Permit, deny, Range, Syntax Permit deny Default Setting

Multicast Filtering Commands 4

Command Usage

A profile defines the multicast groups that a subscriber is permitted or denied to join. The same profile can be applied to many interfaces, but only one profile can be assigned to one interface. Each profile has only one access mode; either permit or deny.

Example

Console(config)#ip igmp profile 19

Console(config-igmp-profile)#

permit, deny

This command sets the access mode for an IGMP filter profile. Use the no form to delete a profile number.

Syntax

{permit deny}

Default Setting

Deny

Command Mode

IGMP Profile Configuration

Command Usage

•Each profile has only one access mode; either permit or deny.

•When the access mode is set to permit, IGMP join reports are processed when a multicast group falls within the controlled range. When the access mode is set to deny, IGMP join reports are only processed when a multicast group is not in the controlled range.

Example

Console(config)#ip igmp profile 19

Console(config-igmp-profile)#permit

Console(config-igmp-profile)#

range

This command specifies multicast group addresses for a profile. Use the no form to delete addresses from a profile.

Syntax

[no] range low-ip-address [high-ip-address]

•low-ip-address- A valid IP address of a multicast group or start of a group range.

•high-ip-address- A valid IP address for the end of a multicast group range.

Default Setting

None

4-299