Accton Technology ES3528M-SFP manual Static Multicast Routing Commands

Multicast Filtering Commands 4

ip igmp snooping router-port-expire-time

This command configures the query timeout. Use the no form to restore the default.

Syntax

ip igmp snooping router-port-expire-time seconds no ip igmp snooping router-port-expire-time

seconds - The time the switch waits after the previous querier stops before it considers the router port (i.e., the interface which had been receiving query packets) to have expired.

(Range: 300-500)

Default Setting

300 seconds

Command Mode

Global Configuration

Command Usage

The switch must use IGMPv2 or v3 snooping for this command to take effect.

Example

The following shows how to configure the default timeout to 300 seconds:

Console(config)#ip igmp snooping router-port-expire-time 300 Console(config)#

Related Commands

ip igmp snooping version (4-289)

Static Multicast Routing Commands

This section describes commands used to configure static multicast routing on the switch.

Table 4-77 Static Multicast Routing Commands

Command	Function	Mode	Page
ip igmp snooping vlan	Adds a multicast router port	GC	4-296
mrouter
show ip igmp snooping	Shows multicast router ports	PE	4-296
mrouter

4-295