Accton Technology ES3528M-SFP manual Spanning-tree loopback-detection trap, Spanning-tree mst cost

Spanning Tree Commands 4

spanning-tree loopback-detection trap

This command enables SNMP trap notification for Spanning Tree loopback BPDU detections. Use the no form to restore the default.

Syntax

spanning-tree loopback-detection trap no spanning-tree loopback-detection trap

Default Setting

Disabled

Command Mode

Interface Configuration (Ethernet, Port Channel)

Example

Console(config)#interface ethernet ethernet 1/5

Console(config-if)#spanning-tree loopback-detection trap

spanning-tree mst cost

This command configures the path cost on a spanning instance in the Multiple Spanning Tree. Use the no form to restore the default.

Syntax

spanning-tree mst instance_id cost cost no spanning-tree mst instance_id cost

•instance_id - Instance identifier of the spanning tree. (Range: 0-4094, no leading zeroes)

•cost - Path cost for an interface. (Range: 1-200,000,000) The recommended range is -

-Ethernet: 200,000-20,000,000

-Fast Ethernet: 20,000-2,000,000

-Gigabit Ethernet: 2,000-200,000

-10 Gigabit Ethernet: 200-20,000

Default Setting

By default, the system automatically detects the speed and duplex mode used on each port, and configures the path cost according to the values shown below. Path cost “0” is used to indicate auto-configuration mode.

•Ethernet – half duplex: 2,000,000; full duplex: 1,000,000; trunk: 500,000

•Fast Ethernet – half duplex: 200,000; full duplex: 100,000; trunk: 50,000

•Gigabit Ethernet – full duplex: 10,000; trunk: 5,000

•10 Gigabit Ethernet – full duplex: 1000; trunk: 500

Command Mode

Interface Configuration (Ethernet, Port Channel)

Command Usage

4-233