Bay Technical Associates V79 PDI-1, V80 PDI-2 owner manual Event Sample Presentation

Page 21

4.5EVENT SAMPLE PRESENTATION

Event Sample presentation varies slightly in format depending on module configuration. Entries such as, time tag, data format, number of active channels, etc. all change how event samples appear to a host-controller. However, all event samples are presented in the same basic order of fields as follows:

UU:MM,CC 1 or 0 MM/DD/YY HH:MM:SS

where, UU is the M Series Unit Number

MMis the PDI Module Number CC is the PDI Channel Number

1 channel status is "closed" (PDI-1) or has voltage applied (PDI-2)

0 channel status is "open" (PDI-2) or has no voltage applied (PDI-2)

MM is the month (if Time Tag enabled) DD is the day (if Time Tag enabled) YY is the year (if Time Tag enabled) HH is the hour (if Time Tag enabled) MM is the minute (if Time Tag enabled) SS is the second (if Time Tag enabled)

The following example shows event samples received using immediate or schedule reporting where the PDI is installed in Unit 1 Module 15 with Time Tagging enabled:

1:15,1 1 11/18/93 09:12:22<cr><lf> 1:15,2 1 11/18/93 09:12:22<cr><lf>

UNIT#
MODULE#
CHANNEL#
CHANNEL STATUS
DATE

TIME

17

Image 21

Contents BayTech Publication #U140E105 Page Table of Contents Reporting Method General V79 PDI-1 Module Specifications V79 PDI-1 Switch Input Status Module V80 PDI-2 Optically Isolated Input Module Cabling InstallationPDI-2 AC Input Setup Operation Sampling Setup USER-PROGRAMMABLE FeaturesReporting Setup Reporting MethodReport Start Time Report IntervalHost Address Dynamic Configuration Data CommandsTerminating Characters Take a single sample for Ports Clear Event Buffer Command Clear Event Counter CommandClear Event Latch Data Report ALL Buffered Events Command Report Event Counter CommandReport Event Duration Command Report Event Latch Data Command Report Event Counter and Reset CommandReport Event Latch Data and Reset Command Event Sample Reporting Report a Single Buffered Event CommandPage Event Sample Presentation 115,1 1320 11/18/93 MENU-DRIVEN Configuration ConfigurationPage Configuration Main Menu Module Status SET Latch Polarity Select Reporting Method Report Start Time Report Interval Enable / Disable Time Tagging Dynamic Configuration Commands Exit Dynamic Configuration Procedure and Commands Debounce Delay Command Reporting Method CommandTime TAG Command Front Panel Configuration Appendix a DATA/CONFIGURATION Command Summary Appendix B Eprom Upgrade Appendix C V79 PDI-1 Mechanical Layout Page Page Appendix D V80 PDI-2 Mechanical Layout Page Page Appendix E Index Fifo Page