Bay Technical Associates V80 PDI-2, V79 PDI-1 owner manual Report Interval

Page 30

IMPORTANT: The Current Date and Time is not updated during data entry. You must consider any delays from the time you enter the Report Start Time until you exit the Configuration Main Menu. Be sure to set the Report Start Time far enough ahead of the current time to complete all configurations and exit configuration mode.

NOTE: When using Schedule Reporting Method and the PDI is initially reporting, if you enter into the menu-driven mode of configuration and exit, the PDI will not resume reporting event samples until the programmed Report Start Time elapses. You may program the PDI without disrupting event sample reporting by using dynamic configuration (see Section 5.2).

5.1.4.3 REPORT INTERVAL

By responding to the Enter Selection: message at the end of the Reporting Setup Menu on page 23 with "3" (Report Interval), you may program the time interval between reporting periods when using Schedule Reporting Method. The PDI will respond with the Report Interval menu as follows:

REPORT INTERVAL

Report Interval

HH:MM

Enter Hours (0-24) <cr>, or X to Exit:

Enter Minutes (0-59) <cr>, or X to Exit:

Enter the desired Report Interval. The Report Interval can range from 1 minute to 24 hours. Once the Report Start Time elapses, the PDI will report all buffered event samples to the designated host module until the buffer is empty. The PDI will continue to transmit all buffered event samples every time the Report Interval expires. For example, if the Report Start Time is 12:00 and the Report Interval is 1:00 (1 hour), the PDI will report all messages in its buffer every hour on the hour starting at 12:00.

26

Page 29 Page 31
Image 30
Page 29 Page 31
Contents BayTech Publication #U140E105 Page Table of Contents Reporting Method General V79 PDI-1 Module Specifications V79 PDI-1 Switch Input Status Module V80 PDI-2 Optically Isolated Input Module Installation CablingPDI-2 AC Input Setup Operation Reporting Setup USER-PROGRAMMABLE FeaturesSampling Setup Reporting MethodReport Start Time Report IntervalHost Address Dynamic Configuration Data CommandsTerminating Characters Take a single sample for Ports Clear Event Buffer Command Clear Event Counter CommandClear Event Latch Data Report ALL Buffered Events Command Report Event Counter CommandReport Event Duration Command Report Event Latch Data Command Report Event Counter and Reset CommandReport Event Latch Data and Reset Command Report a Single Buffered Event Command Event Sample ReportingPage Event Sample Presentation 115,1 1320 11/18/93 Configuration MENU-DRIVEN ConfigurationPage Configuration Main Menu Module Status SET Latch Polarity Select Reporting Method Report Start Time Report Interval Enable / Disable Time Tagging Dynamic Configuration Commands Exit Dynamic Configuration Procedure and Commands Debounce Delay Command Reporting Method CommandTime TAG Command Front Panel Configuration Appendix a DATA/CONFIGURATION Command Summary Appendix B Eprom Upgrade Appendix C V79 PDI-1 Mechanical Layout Page Page Appendix D V80 PDI-2 Mechanical Layout Page Page Appendix E Index Fifo Page
Top Page Image Contents