5.1.2MODULE STATUS
By responding to the Enter Selection: message at the end of the Configuration Main Menu (see Section 5.1.1) with "1" (Module Status), you may review the current configuration status. The PDI will respond with a menu similar to the following:
MODULE STATUS
Debounce Delay (Milliseconds)......100
Latch Polarity | LO to HI |
Reporting Method | COMMAND |
Reporting Start Time | 24:00 |
Reporting Period | 24:00 |
Host Address | 1:1,1 |
Data Format | HEX |
Time Tagging | DISABLED |
Terminating Character(s) | 0D0A |
Dynamic Configuration | DISABLED |
Press a key to continue or X to Exit.
5.1.3SAMPLING SETUP
By responding to the Enter Selection: message at the end of the Configuration Main Menu (see Section 5.1.1) with "2" (Sampling Setup), you may program the Debounce Delay and Latch Polarity. The PDI will respond with the following menu:
SAMPLING SETUP |
|
Debounce Delay | 1 |
Latch Polarity | 2 |
Exit | X |
Enter Selection: |
|
You may program the Debounce Delay the Latch Polarity from this menu. The Exit selection will return you to the configuration main menu. For example, if you type "1" (Debounce Delay), the PDI will respond with the following:
SET DEBOUNCE DELAY
Debounce Delay | .................100 |
Exit | X |
Enter Value<CR>, or X to EXIT:
22