Bay Technical Associates V80 PDI-2, V79 PDI-1 owner manual Select Reporting Method

Page 28

If you respond to one of the above selections with 1 to 6, a sub-menu will be presented for that item. After making any necessary changes under sub-menus 1 to 6, you be returned to the Reporting Setup menu. The "Exit" selection will return you to the Configuration Main Menu.

5.1.4.1 REPORTING METHOD

By responding to the Enter Selection: message at the end of the Reporting Setup Menu with "1" (Reporting Method), you may program how the PDI reports event samples to the host device. The PDI will respond with the Select Reporting Method sub-menu as follows:

SELECT REPORTING METHOD

Reporting Method

....................COMMAND

Command

1

Immediate (When Event Occurs)......2

Schedule

3

Exit

X

Enter Selection:

 

The PDI provides three Reporting Methods. These are Command (via data commands only), Immediate (upon exiting configuration), and Schedule (where reporting begins at a specified time).

When Command Reporting Method is selected, the PDI will report event samples to the host module only when data commands are issued (see Section 4.3.).

When Immediate Reporting Method is selected, the PDI will report event samples to the host module as events occur. If no event has occurred, no event sample is generated. Reporting begins immediately after exiting the Configuration Main Menu

24

Page 27 Page 29
Image 28
Page 27 Page 29
Contents BayTech Publication #U140E105 Page Table of Contents Reporting Method General V79 PDI-1 Module Specifications V79 PDI-1 Switch Input Status Module V80 PDI-2 Optically Isolated Input Module Installation CablingPDI-2 AC Input Setup Operation USER-PROGRAMMABLE Features Sampling SetupReporting Setup Reporting MethodReport Interval Report Start TimeHost Address Data Commands Dynamic ConfigurationTerminating Characters Take a single sample for Ports Clear Event Counter Command Clear Event Buffer CommandClear Event Latch Data Report Event Counter Command Report ALL Buffered Events CommandReport Event Duration Command Report Event Counter and Reset Command Report Event Latch Data CommandReport Event Latch Data and Reset Command Report a Single Buffered Event Command Event Sample ReportingPage Event Sample Presentation 115,1 1320 11/18/93 Configuration MENU-DRIVEN ConfigurationPage Configuration Main Menu Module Status SET Latch Polarity Select Reporting Method Report Start Time Report Interval Enable / Disable Time Tagging Dynamic Configuration Commands Exit Dynamic Configuration Procedure and Commands Reporting Method Command Debounce Delay CommandTime TAG Command Front Panel Configuration Appendix a DATA/CONFIGURATION Command Summary Appendix B Eprom Upgrade Appendix C V79 PDI-1 Mechanical Layout Page Page Appendix D V80 PDI-2 Mechanical Layout Page Page Appendix E Index Fifo Page
Top Page Image Contents