Actiontec electronic 56K V.90 manual

Page 26

Step 9 Click Browse. Navigate to your CD-ROM drive, then double click on the Drivers folder. In Drivers, double-click the Pciwin folder, then double- click the Win2K folder. With the Win2k folder open in the Locate File dialog box, click Open.

Step 10 You will be sent back to the Upgrade Device Driver Wizard, but now the path in the Copy manufacturer’s files from: box is correct. click OK.

Step 11 You will be returned to the Upgrade Device Driver wizard and Windows 2000 will confirm the name and location of the driver. Click Next.

Step 12 Next, windows will report that the drivers have not been tested by Microsoft for use with Windows 2000. Actiontec itself has exhaustively tested this product for use with Windows 2000. Click Yes to continue the installation.

25

Image 26

Contents 56K V.90 PCI Voice/Fax Windows Modem Table of Contents Introduction For Windows 95 and Windows 98 Installations Do This FirstFor Windows NT 4.0 Installation For Windows 2000 Professional Installation Installing The Modem Hardware InstallationInstalling The Modem Connecting Devices to the Modem Connecting DevicesConfiguring Windows Page Configuring Windows 95B Page Configuring Windows Page Next Page Page Configuring Windows NT Page Page Page Configuring Windows 2000 Professional Page Page Page Page Confirming the Installation of the Driver in Windows Page Installing Communications Software Modem’s Voice FeaturesPage Troubleshooting Windows 95/95B/98More Info Panel Does Not Install Windows NT Common Problems No Dialtone ErrorCan’t Connect at 56K Uninstalling the Modem Uninstalling in Windows 95Ltcom.vxd ltwave.inf Page Answer Command AT CommandsRepeat Last Command ATXnCarrier Control Echo Command DnDialOnline Data Character Echo Command Hook ControlMonitor Speaker Volume Request ID InformationThis command turns the speaker on or off Modulation HandshakeResult Code Control Return On-line to Data ModeSelect Pulse Dialing DCE Response Format Result Code OptionExtended Result Codes Dial Tone DetectRecall Stored Profile Busy Tone DetectLong Space Disconnect Auto Retrain Data Carrier Detect DCD Control22bis Guard Tone Control Load Factory SettingsDTR Control Local Flow Control Selection Asynchronous Communications ModeAuxiliary Relay option This Command is effective only for use in Japan View Active Configuration and Stored Profile Data Set Ready DSR OptionLSD Zn=x Store Telephone Number Modem Port Flow Control \An\Bn \Kn Same as 4.Default \Nn \Tn Inactivity Timer \Vn Protocol Result Code\Xn XON/XOFF Pass Through Data Calling ToneV90=x Downstream Rate and Control Write to/Read from DSP Register Enable/Disable Data CompressionAT Commands for Testing and Debugging Line-to-Line LoopbackATI11 XXX Registers Reference TypeAscii S10 Connection Completion Time-OutComma Dial Modifier Time S11 Dtmf Dialing SpeedS22 S14 General Bit Mapped Options StatusS21 S30 Inactivity Timer S24 Timer to Control Sleep ModeS28 Modulation Enable/Disable S32S36 S37 Dial Line Rate defaultS35 Data Calling Tone S43 Auto Mode default 1, range S38 56K Dial Line Rate defaultS42 Auto Rate default 1, range S91 S89 Timer to Control Sleep ModeS90 S92 No CarrierResult Code Declaration of Conformity FCC RegulationsFCC Part 68 Requirements Canadian Department Of Communications Cdoc