Actiontec electronic 56K V.90 manual

Page 18

Step 10 The wizard will find the correct driver on the CD-ROM and announce it is ready to install. Click Next.

Step 11 After Windows has finished copying the drivers to where they belong in your system, it will announce the end of the installation process. Click the Finish button.

17

Image 18

Contents 56K V.90 PCI Voice/Fax Windows Modem Table of Contents Introduction For Windows 95 and Windows 98 Installations Do This FirstFor Windows NT 4.0 Installation For Windows 2000 Professional Installation Installing The Modem Hardware InstallationInstalling The Modem Connecting Devices to the Modem Connecting DevicesConfiguring Windows Page Configuring Windows 95B Page Configuring Windows Page Next Page Page Configuring Windows NT Page Page Page Configuring Windows 2000 Professional Page Page Page Page Confirming the Installation of the Driver in Windows Page Installing Communications Software Modem’s Voice FeaturesPage Troubleshooting Windows 95/95B/98More Info Panel Does Not Install Windows NT Common Problems No Dialtone ErrorCan’t Connect at 56K Uninstalling the Modem Uninstalling in Windows 95Ltcom.vxd ltwave.inf Page Answer Command AT CommandsRepeat Last Command ATXnCarrier Control Echo Command DnDialOnline Data Character Echo Command Hook ControlMonitor Speaker Volume Request ID InformationThis command turns the speaker on or off Modulation HandshakeReturn On-line to Data Mode Select Pulse DialingResult Code Control DCE Response Format Result Code OptionExtended Result Codes Dial Tone DetectBusy Tone Detect Long Space DisconnectRecall Stored Profile Auto Retrain Data Carrier Detect DCD ControlLoad Factory Settings DTR Control22bis Guard Tone Control Asynchronous Communications Mode Auxiliary Relay optionLocal Flow Control Selection This Command is effective only for use in Japan View Active Configuration and Stored Profile Data Set Ready DSR OptionLSD Zn=x Store Telephone Number \An \BnModem Port Flow Control \Kn Same as 4.Default \Nn \Tn Inactivity Timer \Vn Protocol Result Code\Xn XON/XOFF Pass Through Data Calling ToneV90=x Downstream Rate and Control Write to/Read from DSP Register Enable/Disable Data CompressionAT Commands for Testing and Debugging Line-to-Line LoopbackATI11 XXX Registers Reference TypeAscii S10 Connection Completion Time-OutComma Dial Modifier Time S11 Dtmf Dialing SpeedS14 General Bit Mapped Options Status S21S22 S30 Inactivity Timer S24 Timer to Control Sleep ModeS28 Modulation Enable/Disable S32S37 Dial Line Rate default S35 Data Calling ToneS36 S38 56K Dial Line Rate default S42 Auto Rate default 1, rangeS43 Auto Mode default 1, range S89 Timer to Control Sleep Mode S90S91 S92 No CarrierResult Code FCC Regulations FCC Part 68 RequirementsDeclaration of Conformity Canadian Department Of Communications Cdoc